cgminer -o stratum+tcp://:3334 -u 1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr -au3-freq 150 Old cgminer: To build use -enable-icarus flag. The compacs afterwards while cgminer is running to get them to start You have plugged into your windows machine. Run the program and install the winusb driver for the compac(s) that If you need to run cgminer on windows (either stock or mine), you'll Newer drivers for both cgminer and bfgminer depend on a hexfileįlashed to the cp2102 which the engineering samples do not have. On the engineering sample sticks you can only use old cgminer as the YouĬan set the frequency under manual options as: -compac-freq 150. I have not yet tested it but edonkey was nice enough to upload aĬustom minera image with cgminer-gekko enabled as a custom miner. The case of windows) compiled with icarus support. Version supports bitshopper compacs as well, and can be (and is, in misc/cgminer-gekko-win32.zip EDIT: The current I (novak) have written a cgminer driver which enumerates the compacsĪs expected, removes the error, and ramps up the clock slowly to Luke Jr added bfgminer support in bfgminer 5.3.0, so you may use that This is pretty good for most people as that's moderately high power but in theory the chips will run up to 500MHz. These older version of cgminer do not allow a clock rate over 250MHz. If your hardware errors are low you're fine. It may give warnings about "no valid hashes within 3 seconds" but this is fine, as the U3 has a higher hashrate, confusing cgminer but not noticeably affecting performance. The stickminer will enumerate as an antminer U3 on cgminer (if the version of cgminer you're using supports the U3), and should run fine. You can use bfgminer, which from 5.3.0 supports your miner out of the box. I believe you have to get the driver for it. CGMiner doesn't come with support for that particular miner by default.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |